Uplift Desk V2 Standard 4-Leg Height Adjustable Frame Manual page 10

10
© UPLIFT Desk • 800-349-3839 • 512-614-3152 • info@upliftdesk.com • upliftdesk.com
Step 15
If you purchased Casters, remove the leveling pads
and install the Casters now before flipping your desk
over.
With you and your friend on opposite ends of the
desk, grab the Desktop AND Side bracket with one
hand and a Leg in the other. Be aware and be care-
ful of the cables, any attached components or acces-
sories especially an accessory that might move on a
track like a Keyboard tray or CPU holder. Support the
desk frame and the Desktop equally and tilt it gently
rotating it 90 degrees back, so the Keypad is facing up.
Readjust your grip at the Desktop and Side bracket
with one hand and keep the other hand on the Leg.
Lift and rotate 90 more degrees until your Desk is
right-sideup. Adjust the leveling studs or Casters as
needed to make the desk level.
Step 16
Position your desk where you'd like it to be. Keep it
close to a wall outlet and away from obstacles which
may interfere with the desk's height adjustability range.
If your desk has Casters: Moving is easy! Make sure the
casters are unlocked and roll it to the desired position.
If your desk does not have Casters: Using three peo-
ple, lift your desk (do not drag it) by holding onto the
Side bracket (marked with arrows, to the left).
Note: Never lift by holding on to the Desktop itself, as
this will put undue stress on the screws.
Once the desk is in position, proceed to the next step.
Step 17
Check your desk's surroundings to make sure there
will be no obstacles in the desk's path and that all
cords are long enough to accommodate the motion
of your desk.
Plug your desk into a 120V outlet.
Before using your desk, you'll need to sync all the com-
ponents by using the reset procedure.
Initial Desk Reset Procedure
Press and hold the DOWN button for 10 seconds, then
release the button.
Press and hold the DOWN button again, the desk will
lower a little, then rise a little, and then stop. Release
the button. Your desk is now ready for use!
If you are using a Memory keypad, see additional key-
pad instructions for further information on how to use
your keypad.