Display Units - Uplift Desk V2 Standard 4-Leg Height Adjustable Frame Manual

Hide thumbs Also See for V2 Standard 4-Leg Height Adjustable Frame:

Table of Contents

DISPLAY UNITS

Change the numeric display to show heights in either inches or centimeters.

Hold the DOWN button on the Keypad until the desk reaches the lowest height, then release.

2. Hold the DOWN button again until display flashes "RST".

3. Press the "2" button until display shows "10.3" (centimeters) or "10.4" (inches) and goes

back to "RST".

Note: While "RST" is still flashing, you can press the "2" button as many times as you'd like

to toggle between the two settings.

4. Hold the DOWN button until the desktop lowers slightly, then rises slightly and the display

changes back to the numeric height setting, then release.

MINIMUM & MAXIMUM HEIGHT SETTINGS

The desk frame ships defaulted to its minimum and maximum height limits. These steps allow the

upper and lower limits to be adjusted to your preference.

To Set a new maximum desk height:

Use the UP or DOWN buttons to bring desk to the desired maximum height.

2. Press the "M" button once, and "S-" will appear on the display. Immediately follow by

pressing the UP button once, so the "S-" flashes once.

3. Hold the "M" button until the Display shows "999" then changes to numeric value of new

upper limit.

To Set a new minimum desk height:

Use the UP or DOWN buttons to bring the desk to the desired minimum height.

2. Press the "M" button once, and "S-" will appear on the display. Immediately follow by

pressing the DOWN button once, so the "S-" flashes once.

3. Hold the "M" button until the Display shows "000" then changes to numeric value of new

lower limit.

Removing adjusted maximum and minimum heights:

Press the "M" button once and the display will show "S-".

2. Hold the "M" button again until the display shows "555" then changes to the current

numeric height setting.

Note: If memory settings were previously set outside of the new minimum and maximum height

settings, they will default to the new minimum and maximum settings. To set new minimum and

maximum height settings outside of the current settings, you will need to first remove the current

minimum and maximum settings.

PROGRAMMING (continued)

Table of Contents

Do you have a question about the V2 Standard 4-Leg Height Adjustable Frame and is the answer not in the manual?