Uplift Desk V2 Standard 4-Leg Height Adjustable Frame Manual page 6

Hide thumbs Also See for V2 Standard 4-Leg Height Adjustable Frame:

Table of Contents

Step 5

Place your Desktop upside down on a debris-free

carpeted area or a blanket. Make sure the Desktop is

upside down. If your Desktop has pre-drilled holes or

threaded inserts, they should be visible and facing up.

Align the holes in one Side bracket (C4) with the pre-drilled

holes or threaded inserts on one side of the Desktop. Make

sure that the beveled edge of the Side bracket is pointed

towards the front of the Desktop. Then attach it with three

of the screws chosen in Step 4.

Be careful to not over-tighten, to avoid stripping.

Step 6

Slide two Leg assemblies onto the tabs of the Side

bracket. Connect them to the Side bracket with four

M6x10 Machine screws (H1).

Rotate each screw by hand for only a few turns to

avoid cross-threading. Once the four screws are start-

ed, tighten all the way using the 4mm Allen wrench

(H6).

Step 7

Orient all the Crossbar rails (C3) so that the Center

indicator marks are facing up. When pairing two

rails together, make sure the slots are facing inward

(towards each other) and the slot on the Crossbar rails

is farther from the floor, as shown below.

Center indicator marks

Insert two Crossbar rails (C3) into each Crossbar end

(C2) as far as they will go. Take the other two Leg as-

semblies and slide them onto the Crossbar rails as far

as they will go.

Table of Contents

Need help?

Do you have a question about the V2 Standard 4-Leg Height Adjustable Frame and is the answer not in the manual?