Accessory Instructions - Uplift Desk V2 Height Adjustable Bamboo Conference Table Assembly Instructions Manual

H14
C5
Now is a good time to install accessories such as casters, wire management, or any other item to the
bottom of your table. This section covers accessories that are included with this Frame.
8
© UPLIFT Desk • 800-349-3839 • 512-614-3152 • info@upliftdesk.com • upliftdesk.com
C7
HS M1 M2 M3 M4

ACCESSORY INSTRUCTIONS

C10
Step 11
Plug the Power cable (C7) into the power socket on
the Control box (C5) marked "AC".
Line up your Control box (C5) with the pre-drilled
holes in the Leaf table section*, and attach it to ta-
ble top with two #10x5/8'' Wood screws (H14) each.
There is a port on one of the long sides of the con-
trol box. Be sure that this port is facing away from the
Crossbar rail if you plan to use the UPLIFT Desk Con-
nect dongle and app with your table.
*If assembling a Conference table without the Leaf
table section, you will use one pre-drilled hole on each
of the Main table sections.
Step 12
Plug each Leg into a Leg cable (C8), and then plug
the Leg cable into the white ports on the Control box
marked "M1", "M2", "M3", and "M4". It doesn't matter
which leg is plugged into each port.
Plug the Keypad (C6) into the port labeled "HS".
Table Cable Management:
Use the included Cable mounts (H9) to organize your
wires, keep a clean presentation, and prevent any wires
from snagging on anything when adjusting height. The
Cable mounts work best when stuck directly to the
metal table frame. Attach Cable mounts to the inside
of frame parts. You might want to save some for once
you have everything on your table plugged in.
Installing the Wire Management Tray:
You can install the Wire Management Tray (C10) while
you're assembling your table. Find the placement you
want, and make a pencil mark at each mounting hole
location.
Attach the tray to your table using two #10x5/8''
Wood screws (H14).
If you own a drill, you can make this a little easier by
drilling pilot holes where you've made your pencil
marks using a 1/8" diameter bit.
Note: DRILL NO DEEPER THAN 1/2". To ensure
this, we recommend wrapping a piece of tape
around your drill bit 1/2" from the tip. Stop drill-
ing just before the tape touches the desktop.
1/2''