Uplift Desk V2 Standard 4-Leg Height Adjustable Frame Manual page 7

Hide thumbs Also See for V2 Standard 4-Leg Height Adjustable Frame:

Table of Contents

Step 8

Align the holes in the second Side bracket (C4) with

the pre-drilled holes or threaded inserts on the other

side of the Desktop. Once again, make sure that the

beveled edge of the Side bracket is pointed towards

the front of the Desktop. Then attach it with three of

the screws chosen in Step 4.

Be careful to not over-tighten, to avoid stripping.

Slide two Leg assemblies onto the tabs on the Side

bracket and connect them to the Side bracket with

four M6x10 Machine screws (H1).

Once all the screws are inserted, tighten down the

screws using the 4mm Allen wrench (H6).

Step 9

H4 a

Once the Side brackets and Crossbar ends are in

place, attach the Crossbar ends to the Desktop us-

ing four of the #10x3/4'' Wood screws (H4a) and four

Washers (H5).

Make sure all screws are started before fully tighten-

ing them.

If you own a drill, you can make pilot holes to make this

a little easier. Use it with a 1/8" diameter drill bit and,

ensuring that you DO NOT DRILL DEEPER THAN 1/2",

drill pilot holes where you've made your marks. Check

that the frame assembly is in the right location prior

to drilling by confirming that your marks are lined up.

Step 10

Slide each Crossbar rail (C3) until the Center indicator

mark is in the middle. Once this is done, the Crossbar

rail will be centered and in the proper position.

Insert four M8x8 Set screws (H3) into the holes on

each Crossbar end to secure each Crossbar rail.

Tighten using the 4mm Allen wrench (H6).

Table of Contents