Uplift Desk V2 Standard 4-Leg Height Adjustable Frame Manual page 5

C1
H1
H12
Machine screw: flat end
Wood screw: pointy end
© UPLIFT Desk • 800-349-3839 • 512-614-3152 • info@upliftdesk.com • upliftdesk.com
DESK ASSEMBLY INSTRUCTIONS
C2
H1
C4
H4 c
H4 d
Step 1
Count all pieces before disposing of any packing
material. Inspect both sides of your desktop for
damage. To avoid any damage to your floor or your
desk, assemble on top of a debris-free carpeted area
or a blanket.
For ease and safety, we recommend two people for
assembly.
Before assembly, consider where you want your desk
to be located. Since your new desk is height adjustable,
you will want it located a safe distance from window
frames, furniture, radiators, or anything else that
could obstruct the desk from raising or lowering. Do
not place any objects underneath the desk that are
taller than 21", and consider any accessories mounted
to your desk that would lower even further than the
desk itself.
Step 2
Place Crossbar ends (C2) upside down as shown.
Insert the Leg (C1) so that the back of the Leg and the
back of the Crossbar end are flush.
To avoid cross-threading and to ensure all the screw
holes are lined up, start the four M6x10 Machine screws
(H1) by rotating each for only a few turns through the
Crossbar end holes into the Leg as shown, but do not
tighten them all the way.
Once all four screws have been started, tighten them
all the way using the 4mm Allen wrench (H6).
Repeat this step for the other 3 Legs.
Step 3
Peel off four Adhesive pads (H12) from the backing
and place onto one of the Side brackets (C4) where
shown.
Repeat for second Side bracket.
Step 4
For Desktops with Threaded Screw Inserts: You'll
be using the #10-24x5/8" Flathead Machine screws
(H4c) to attach the Side brackets (C4) to the desktop.
For Desktops without Threaded Screw Inserts: You'll
be using the #10x5/8" Flathead Wood screws (H4d)
to attach the Side brackets (C4) to the desktop.
5