Jumper Setting; Jp1 : A/D Input Type Selection; J1 : D/A Reference Voltage Selection; D/I Port Setting (Pci-1202Hu/Lu/1602U/1602Fu Only) - ICP DAS USA PCI-1202 Series Hardware User Manual

2.2 Jumper Setting

2.2.1 JP1 : A/D Input Type Selection

This jumper is used to select the analog input type. For single-ended inputs,
the use should connect pin1, 3 and pin2, 4. For differential inputs, pin3, 5 and pin4,
6 should be connected.

2.2.2 J1 : D/A Reference Voltage Selection

J1 is used to select the internal D/A output reference voltage. To select the
±10 V voltage output, the pin 1&2 should be connected. To select the ±5 V voltage
output, the pin 2&3 should be connected.
2.2.3 D/I Port Setting
This DI ports can be pull-high or pull-low selected by JP2. The location is
given as following:
JP2
PCI-1202/1602/1800/1802 Hardware User's Manual
JP1
1
2
5 6
Single-Ended
Inputs (default)
J1
1
±
10 Voltage
output (
default)
(PCI-1202HU/LU/1602U/1602FU only)
3
2
1
Pull High
JP1
2
1
6
5
Differential
Inputs
J1
1
± 5 Voltage
output
3
2
JP2
1
Pull Low
(Ver.4.2, Dec/2009, PMH-014-42)---- 20