Jumper Setting
Please make sure J1/J2/J3/J4 jumper is kept in default setting before self-test,
as follows: (
Jumper
Installing Hardware on PC
Step 1: Shut down and power off your computer.
Step 2: Remove the cover from the computer.
Step 3: Select an unused PCI/PCI Express slot.
Step 4: Carefully insert your I/O card into the PCI/PCI Express slot.
Step 5: Replace the PC cover.
Step 6: Power on the computer.
After powering-on the computer, please finish the Plug&Play steps according
to the prompted messages.
PEX-P64/PISO-P64U Series Quick Start Guide
3
WebSite: http:// www.icpdas.com.tw
This example uses this power supply.)
E-Mail: service@icpdas.com , service.icpdas@gmail.com
J1/J2/J3/J4
ICP DAS CO., LTD.
Internal Power
External Power
(Default Setting)