Table of Contents
Advertisement
Maintain the 3410 and 5410N
c. Position the slotted end of the handle in the upper sensor. Refer to
page 29 for the sensor locations.
Tip: One end of the handle has a slot with a notch in it
approximately ¼ inches from the end. This is the end that goes into
the printer.
d. Position the can of compressed air's nozzle in the unnotched end of
the handle.
e. Blow compressed air into the end of the handle for one
to two seconds.
f.
Repeat two to three times.
4. Clean the lower sensor.
a. Locate the swab and handle found in the Everest Cleaning Kit.
b. If necessary, remove the swab from the handle.
c. Position the slotted end of the handle in the lower sensor. Refer to
page 29 for the sensor locations.
Tip: One end of the handle has a slot with a notch in it
approximately ¼ inches from the end. This is the end that goes into
the printer.
d. Position the can of compressed air's nozzle in the unnotched end of
the handle.
5. Prepare the system for use.
For more information visit
rimage.com/support
e. Blow compressed air in to the end of the handle for one to two
seconds
f.
Repeat two to three times.
a. Replace the print ribbon carrier.
b. Replace the retransfer ribbon carrier.
c. Close the printer cover.
d. Power on the system.
Connect the power cord to the back of the 5410N or 3410.
i.
ii. Connect the power cord to the power outlet.
iii. Power on the 5410N or 3410. Refer to the
section on page 12 for detailed instructions.
The system is ready for use.
Power On the System
30
Advertisement
Table of Contents
