Gree A Series Service Manual page 45

A Series Modular-type Air-cooled (Heat Pump) Chiller
No
Entering water-T
1
Leaving water-T
2
Defrosting temperature 1
3
Defrosting temperature 2
4
Discharge temperature 1
5
Discharge temperature 2
6
Anti-freezing-T
7
Anti-over-heating-T
8
Ambient temperature
9
[Note]
1)"N/A" will be displayed when the temperature value for the corresponinidng mode or unit
doesn not exist or is invliad.
2)For item 7 and 8 in the table above, when "Mode" is set to "Cool", only "Anti-freezing-T"
will be displayed; when "Mode" is set to others, only "Anti-over-heating-T" will be displayed.
(3)Error
Operation Instruction
By touching"Error", the control will access to the error check page. When there is no any
error, the control panel will show as below.
Fig 4-16 Parameter Page 4
Name No
Suction temperature 1
10
Suction temperature 2
11
12 Shell-and-tube inlet-T 1
13 Shell-and-tube inlet-T 2
14 Shell-and-tube outlet-T 1
15 Shell-and-tube outlet-T 2
Water-T for energy saving
16
High pressure sensor 1
17
High pressure sensor 2
18
40
Name