Gree A Series Service Manual page 124

2. Take out
the coils, pipe
clamps and
rubber pads.
3. Desolder
connection
pipes.
4. Take out
the main body.
A Series Modular-type Air-cooled (Heat Pump) Chiller
(1)Take out coils;
(2)Loosen screws and take out
(3)Wrap the valve with wet cloth
(1)Desolder connection pipes and
(2)Do charge nitrogen during de-
(3)Protection measures should
Take out the main body of the
electrostatic expansion valve.
119
pipe clamps and rubber pads;
to prevent the sliding block from
being burn out. In this case,
care must be taken to not let
water enter the pipe.
then disconnect them with the
main body of the valve;
soldering;
be taken during soldering to
prevent surrounding objects
from being burnt out.