Gree A Series Service Manual page 119

A Series Modular-type Air-cooled (Heat Pump) Chiller
1. Remove
the front
panels.
2. Remove
power lines
and the
electric
heater.
3. Disconnect
power lines to
the
compressor.
114
(1)Remove screws at the
front panel;
(2)Loosened screws
should be put together
to avoid loss;
(3)Pull the front panel
upwards and then
remove it;
(4)Properly keep the
removed front panel to
avoid from being
damaged.
Note: there are two clasps
at each panel for
connecting with side
panels.
(1)Remove the insulation
of the compressor;
(2)Loosen screws of
power lines with a
screwdriver;
(3)Draw out power lines;
(4)Draw out the electric
heater.
Note: power lines and their
terminals should be
numbered to avoid
incorrect rewiring.
(1)Desolder pipes quick
to avoid deformation;
(2)Keep the replaced
compressor complete
for further analysis.