Gree A Series Service Manual page 31

A Series Modular-type Air-cooled (Heat Pump) Chiller
(4)At the desired function setting page, touching"OK" will save the setting and
touching"Cancel" will exit this setting. Meanwhile the control panel will back to the function
setting page under both conditions.
[Notes]
1)When there is submenu for the desired function option, by touching it, the control panel
will access to the sub-menu setting page.
2)At the setting page, press "OK" finish and save this setting. However, in this case, there
will be no alert message.
3)At the function setting page, when any function status is changed and memorized, it will
resume the changed status upon next power-on.
See the table below for more details about each function.
No Parameter Name
1 Mode
Electric heating
2
Auto anti-freezing
3
4 Contact-control ON/OFF
5 Timer ON/OFF
Timer setting
6
Manual defrosting
7
ON/OFF memory
8
Energy-saving mode
9
10 Quiet mode
Remote monitoring address
11
Resetting
12
Field commissioning
13
Factory commissioning
14
(1)Mode
Operation Instructions
At the function setting page, when the unit is OFF, by touching "Mode", the control panel
will go to the corresponding setting page. Then, select the desired option. After that, by
Range
Manual-defrost; Heat;
Cool
Off; On
Off; On
Disabled; Enabled
Disabled; Enabled
Enter
Enter
Off; On
Off; On
Off; On
1~255
Enter
Enter
Enter
26
Interpretation
It can be set under the OFF
status.
It is unavailable for the cooling
only unit.
/
/
It allows the unit to be timed
on or off.
It is used to set the timer.
It can be set when the unit is
off and "Mode" is set to
"Manual-defrost".
/
/
/
/
Except the language setting
/
/