Product Editing Screen - USC Seed Wheel Operator's Manual

1
2
3
4
1. PRODUCT NAME:
allowing the operator to change an existing product name. If an unused box was
selected from the list, the name will be blank and the Calibration Ratio will be 1.0,
allowing the operator to enter a new product into the system. Once saved, it will be
added to the list.
2. SCU BUTTONS:
second is used to enter the seed count per unit, and the third defines how many units
per minute to run for this product. The Units Per Minute drives the flow rate when the
Measure By button is set to SCU. Notice when you change the units it also updates
the seed flow rate number even though the button is inactive.
3. SEED FLOW RATE:
the seed flow rate to run for this product. The Seed Flow Rate drives the flow rate
when the Measure By button is set to CWT. Notice when you change the flow rate it
also updates the units per minute number even though the button is inactive. This
number must match the seed flow rate of the treater.
. CUP WEIGHT:
4
from this product (see page 35). This button will only be present if the Cup Weight
Option is enabled on the Setpoints screen. If it is not, the system defaults will be used
(see page 34).
5. SCREEN EXIT:
It's functionality is the same throughout all of the HMI screens.
6. CALIB.:
Pressing this button takes the operator to the Calibration Calculator
screen (see page 28).
7. CLEAR:
This button deletes the name and resets the Calibration Factor to 1.00.
After a new name and calibration factor has been entered, press the save button.
This is another way to enter a new product name in the system.
Seed Wheel

PRODUCT EDITING SCREEN

When this button is pushed an alpha numeric keypad appears
The first button is used to enter the seed count per pound, the
Pressing this button brings up a numeric keypad to enter
This button is used to enter the weight from the cup sample taken
This button is used to return to the previous screen.
5
6
7
8
9
10
Page 27