USC Seed Wheel Operator's Manual page 13

7. On LP800 models only, insert the flow balancer
(figure 2) in the cone of the seed treater so the ends
of the flow balancer are directly under the bottom
openings of the seed wheel. Holes can be drilled to
mount the flow balancer permanently in the seed
treater.
8. Install the four pieces of foam seal on top of the
seed treater flange.
9. Set the seed wheel on the seed treater using the
alignment bolts on the seed wheel. The junction
box should be facing forward above the seed treater
panel. The seed wheel will rest on top of the foam
seal. (figure 3)
DO NOT
alignment bolts of the seed wheel.
NOTICE
The two nuts should be threaded next
to each other.
10. After setting the seed wheel on the seed treater, use the 3/8 flange nuts to tighten
the seed wheel to the seed treater. Use the following steps to secure the seed
wheel to the treater.
A
( ): Use the center nut and thread it to the bottom flange.
B
( ): Install the 3/8" flange nut to the alignment bolt.
C
( ): Tighten the bottom nut and center nut together against
the seed treater flange. This will secure the seed
wheel to the treater and keep the bottom plate of the
seed wheel flat so the wheel does not bind.
Seed Wheel
Foam Seal
remove the two nuts from the
Place these ends directly
under the bottom openings of the
seed wheel. (LP800 models only)
Figure 2: Flow Balancer (LP800)
Figure 3
Page 13