Tower Seed Treater - USC Seed Wheel Operator's Manual

MOUNTING SEED WHEEL TO TOWER TREATER
1. To install a seed wheel on an existing tower seed treater, you must first remove the
seed treater from the tower. This will allow for easier installation. After the treater
has been removed, follow steps 1 through 16 on pages 12-15 to install the seed
wheel.
2. Set the seed treater back on the tower stand.
3. Install the tower leg extensions on box stand and mount box stand back over the
seed treater.
4. Open the adjustable seed gate to its most wide open position. If the seed gate is
not open fully, seed flow will be diminished and may even back up into the seed
wheel.
5. Set the platform steps on the tower platform. The steps will allow easier access to
the gate on the seed box and the Seed Wheel control panel.
Seed
Wheel
Seed Wheel
Seed Wheel on Tower Seed Treater.
Page 17