Xerox B210 Service Manual page 90

9. Disconnect the Drive Motor connector, then remove the ground screw,
Screw
Figure 4 Drive Motor Connector & Ground Clip (Bottom View)
10. Remove three screws in the left frame,
11. Remove four screws, then remove the Drive Motor,
Figure 5 Drive Motor
Initial Release
Xerox® B210 Service Manual
Figure 4.
Connector
Figure 3.
Figure 5.
Drive Motor
Replacement
Replacement is the reverse of the removal procedure.
NOTE: Tapered Plastic Screws and Round Machine Screws are used to hold the PWB to the
frame. Make sure that the Plastic Screws go into plastic components and Machine Screws go
into the metal frame.
1. Install the new Drive Motor.
NOTE: The Frame is flexible and can be bowed out if the screws are not tightened in the
correct order.
Reinstall the Frame as follows so it seats flush against the printer internal modules.
2. Align the Frame on to the internal modules and shafts.
NOTE: Do Not fully tighten the screws in Step 3 until instructed.
3. Install, but do not tighten, the following module screws,
a. The two Fuser Module screws.
b. The three Middle Frame screws.
Step 5c
Step 3a
Figure 6 Frame Screw Installation
July 2019
4-37
Figure 6:
Step 5b
Step 3b
Repairs - Adjustments
REP 4.15