Xerox B210 Service Manual page 26

03-900 Main PWB Motor Control Chip RAP
BSD-ON:BSD 1
The Motor Control Chip on the Main PWB is not functioning normally.
Procedure
1. Switch off, then switch on the machine.
2. If problem continues, Install a new Main PWB,
Initial Release
Xerox® B210 Service Manual
PL 1.1 Item 7.
July 2019
04-500 Main Drive (BLDC) Motor Start RAP
BSD-ON:BSD 1
The Main Drive (BLDC) Motor did not start within the specified time after the ready signal was
sent.
Initial Actions
• Switch off the machine, then switch On the power.
Procedure
Remove the Right Cover REP 2.2, then check the motor connector on the Main PWB. The
connector on the Main PWB is securely connected.
Y N
• Verify there is no contamination present.
• Check for broken and defective wires or cables.
• Securely reconnect the motor connector.
Manually rotate the Main Drive Unit. The Main Drive Motor rotates freely.
Y N
Install a new Main Drive Unit, REP
The Main PWB is defective.
• Install a new Main PWB, PL 1.1 Item
If the problem persists, Install a new Main PWB,
2-5
4.17.
7.
PL 1.1 Item 7.
Status Indicator RAPs
03-900 , 04-500