Xerox B210 Service Manual page 89

7. Remove the following items, Figure
Note the order the Feed and Registration Drive Gears are removed for correct installation
during the replacement procedures.
a. Remove the snap-ring, then remove the Feed and Registration Drive Gears.
b. Remove two snap-rings, then remove two Feed and Registration Clutch Bushings.
c. Remove two screws, release the latch, the remove the Exit Drive Gears.
Exit Drive Gears
Feed & Registration Drive Gears
Figure 2 Drive Gears and Bushings
Repairs - Adjustments
REP 4.15
2:
CAUTION
Snap Ring
Clutch Bushings
8. Remove the following from the left frame,
a. Release two latches, then remove two Shaft Bushings.
b. Remove two screws securing the LSU support.
c. Remove five screws securing the Middle Frame and Pickup Frame Base.
Step 8c
Step 10
Figure 3 Frame Screw Removal
July 2019
4-36
Figure 3:
Step 8b
Step 8c
Step 8a
Initial Release
Xerox® B210 Service Manual