Fastcorp DIVI Setup And User Manual page 37

Allows the picker tip to lower the product before it is released into the Delivery Bin. The release height may be adjusted
and Soft Drop may be turned "ON" or turned "OFF".
* = Next
*=Turn Off
*=Turn Off
32. Instructions to Flash Update DIVI Firmware PRIOR to V119K
Necessary tools and components:

Micro SD Card – 1 to 2 GB.
Note: DIVI program updates can be sent via e-mail and saved to a Micro SD Card. This may require the use
of an SD adaptor and / or possibly a USB adaptor.
A. Open the DIVI machine door and turn the VMC power "OFF". The power switch is located on the left
side of the Power Supply under the delivery bin.
B. Open the inner door located to the left of the window opening.
C. The VMC Board is located at the top of the opening and the Digital Display Board is located directly
below the VMC. Unlatch the right side of the Display Board and flip it around so that the display may
be viewed from the back of the door.
D. The Microprocessor (daughter) Board is located on the upper right corner of the VMC Board. Remove
the Micro SD card from its SD Adapter and carefully insert it into the metallic slot located on the upper
right corner of the daughter board.
1. The Micro SD card should be inserted straight down into the slot.
2. The contacts on the Micro SD card must face away from you.
3. The lettering on the card will be facing you.
4. There should be an audible "click" when the card is seated.
5. If the card does not drop smoothly into the slot, remove and retry.
***DO NOT FORCE THE MICRO SD CARD INTO THE SLOT**
DIVI Setup and Users Guide
W. Soft Drop –
Display
24) Soft Drop
D = Back
Use Up / Down Keys
#=Accept
Saved
#=Accept
Fastcorp, LLC
a) Press the #=Yes key to enter Menu Option.
# = Yes
b) Use Service Keypad up/down keys to adjust soft drop
level and press #= Accept.
c) Press * to turn function "OFF".
New Soft Drop release height is saved.
Page 37 of 62
Programming Instructions
Rev 6