Fastcorp DIVI Setup And User Manual page 19

DEFROSTING THE FREEZER:
Do not use mechanical devices or other means to accelerate defrosting other than the included ice scraper.
Failure to comply could result in freezer damage, fire, explosion, and death.
(1) Depending on usage, temperature, humidity, and maintenance practices, frost will accumulate. It
will eventually become necessary to defrost the freezer.
(i)
unplug the vendor.
(ii)
(i)
temperature.
(ii)
(iii)
front of the freezer. A wet/dry vac or a sponge may be used depending on the volume of water.
Ensure freezer is completely clean and dry before proceeding. Wet bins will deteriorate quickly
(2)
and will freeze in place. Install bins in their proper locations, turn on the freezer, and load product after
the freezer reaches operating temperature.
(iv) Test-vend each selection to verify accuracy of the robot. Edit locations as necessary.
(3) Under most conditions, the DIVI Vendor may lose power for up to 12 hours without compromising
the quality of the product if the freezer remains closed. If freezer temps reach unsafe levels, the health
sensor will activate and the machine will be placed out of order.
16. Health Sensor Active Guidelines
When the machine is placed out of service with a Health Sensor Active, the product must be inspected before
the machine can be reset and placed back in operation. Often only the top two or three items in each bin will
have melted. If the machine loses power for an extended period of time, the product must be discarded and
the freezer and bins will have to be cleaned before the machine can be placed back in service.
and food safety
Fastcorp, LLC
DIVI Setup and Users Guide
Press the "LOAD" button, allow freezer to open completely, then turn OFF machine and
Note: Take a picture or verify that a bin plan-o-gram is correct to your freezer / bin layout.
Remove all of the bins.
Knock ice off the bins as best as possible and set aside to dry thoroughly.
Place the product in an appropriate holding container that will keep product at its correct
Scrape off and remove ice from the freezer chest.
Drain freezer water into a pan. Plugs are located on the inside freezer floor and outside
info.
Page 19 of 62
See sanitation
Rev 6