Fastcorp DIVI Setup And User Manual page 27

d) Release the reset button and press the #-Yes button. You will be prompted to "SET ARM AT LEFT WALL".
Position the arm shown in figure 9A in the previous section. Press the "#" key to accept. Display will show
"SELECTION STORED
e) Now you will be prompted to "SET ARM AT DELIVERY". Position the arm as shown in figure 9B in the previous
section. Press the "#" key to accept. Display will show "SELECTION STORED"
30. ERASE ALL PROGRAMMED INFORMATION:
a) On occasion it may become necessary to erase all programmed and sales data.
b) Press the VAC button on the Service Keypad to release the security locking feature.
c) Go to the Service Menu and press the "*" key repeatedly until the display reads, "4) Create Selection". Press
and hold the Reset button. The VMC will beep as you hold the Reset button. The display will immediately
read:
d) Continue holding the Reset button. The VMC will continue to beep. The display will change to:
e) Continue holding the Reset button. The VMC will continue to beep. The display will change to:
f) Release the reset button and press the #-Yes button. You will be prompted to "SET ARM AT LEFT WALL".
Position the arm shown in figure 9A in the previous section. Press the "#" key to accept. Display will show
"SELECTION STORED"
Fastcorp, LLC
DIVI Setup and Users Guide
Arm Uncalibrated
*-Next D-Back
THIS FORCES RE-SETUP
*-Next D-Back
ARM UNCALIBRATED
*-Next D-Back
PRODUCTS CLEARED
*-Next D-Back
Page 27 of 62
#-Yes
#-Yes
#-Yes
#-Yes
Rev 6