Daedong DSC62 Manual page 24

1-14 DSC62
1. Label C7323-79232
WARNING
1. It is strictly forbidden to approach the reaping
unit.
2. the engine must be shut off prior to maintenance,
cleaning or troubleshooting of the reaping unit.
3. never put in your hand or foot as the cutter in
running may cut off your hand or foot.
2. Label C7323-79182
Unlocking
position
Location B
Positioning device
DSC62-영문판-1장.indd 14
WARNING
the reaping unit may suddenly drop to
cause injuries when it is lifted for the fol-
lowing 3 points must be followed:
1. the lowering/raising cylinder position-
ing device of the reaping unit must be
locked out.
2. the lowering/raising lever of the reaping
unit must be locked out.
3. use hard object such as wooden block
to support the reaping unit.
the method for using secur-
ing device:
Location A 1. raise the reaping unit to
the highest position.
2. take off the cotter pin at
location A and put the
securing device at the
locking position.
3. take off the cotter pin at
Locking
position
location A and insert it into
location B. please follow
the reverse sequence for
removing the securing
device.
3. Label C7321-43292
It must be folded when trans-
ported on the road, otherwise
CAUTION
incident may occur.
4. Label C7313-62181
under this cover, there is a spinning
part that can cause serious injuries.
Do not put your hand under this cover
when operating the combine. Before
Caution
performing any inspection, adjustment
or cleanup, shut off the engine first.
5. Label C7313-64292
WARNING
1. Hand contact with the rotating
banding wheel inside will result
in injuries. never put hands in-
side to install the cover.
2. Shut off the engine during main-
tenance and adjustment.
3. Install the cover after mainte-
nance or adjustment is com-
pleted.
4. Operate the machine only when
all covers are in place.
2012-04-17 오전 10:20:21