Daily Cleaning - Falcon P Series User Manual

15.1 • THOROUGH CLEANING ...
... is a prerequisite for faultless cooking and
better yields:
• the food's own flavour remains unchanged;
• during operation there are no fumes caused
by burnt food residue;
• energy savings;
• less maintenance work and a longer service
life;
• the simplicity of the procedure means that a
thorough clean can be carried out quickly and
with minimum inconvenience to the operator:
Activate automatic cooling with key 13 if the
oven is very hot.
Turn on the "CL" oven cleaning cycle to
remove day-to-day dirt.
Switch on the oven with key 1.
Press key 4, the display 6 will blink "MAN", turn
the knob 7 to the right until "CL" appears. Press
key 15 to turn on the MANUAL wash program
explained below.
Cycle 1 - Cooling/preheating:
the display shows "rAF" if the oven temperature
is high, "Att" if the oven temperature is
low, on reaching the temperature, it shows
"dEt In", the light of key 15 blinks to indicate
a TEMPORARY STOP, a beep signals it is
time to open the door and spray detergent in
the oven. Close the door and press key 15 to
turn the wash cycle back on, after which the
operator needs to take no other action until the
end of the program.
Cycle 2 - Cleansing action
Cycle 3 - Steam cycle
15 • DAILY CLEANING
MANUAL WASH
15.2 • CAUTION
15.3 • It is recommended to use a specially
23
90024720rev00
If considerable deposits form on the drain filter
in the middle of the bottom of the cavity, clean
so as to ensure water and detergent flow out
freely.
The end of the program is defined by a
cyclic beep, open the door to turn it off.
Switch off the appliance with key 1.
It is a good rule at the end of the washing
cycle to rinse the inside of the oven again
with the shower (optional), wipe the front
seal of the oven with a sponge or cloth to
protect it from early deterioration.
Never use direct or high-pressure jets of
water to clean the outside of the oven.
Never use corrosive and/or abrasive
substances on steel surfaces, and avoid
scouring or scrubbing with steel wool or wire
brushes, as this could result in irreparable
damage. Similarly, aggressive detergents,
of non-alkaline formulation containing high
percentages of sodium and ammonia, can
soon damage the seals, jeopardizing oven
efficiency and operation.
The outside of the oven should be washed with
a sponge and warm water with an ordinary
detergent suited to the purpose.
formulated detergent.
CUBECLEAN
Alkaline detergent
in a tank
CUBECLEAN
10 lt.
DL 010