Entering And Saving A Program - Falcon P Series User Manual

6.1 • SWITCH ON THE OVEN
Press key 1.
6.2 • SELECT THE PROGRAM
Press the programming key 4, and turn
knob 7 to select the number you want to
give the cooking program, shown in the
display 8.
Caution
The program is "new" when the LEDs of the
cooking mode keys blink.
The program is "busy" when at least one
LED of the cooking mode keys blinks.
6.3 • SELECT
The LEDs of the cooking mode keys all
blink. Press the key of the required
cooking mode (2 - 3 / 2+3) for cycle 1:
the LED of the chosen cooking mode stays
on with a steady light (while the other one
goes out) or, in combi mode, with both
lights on steady.
6.4 • SET THE TEMPERATURE OF
CYCLE 1
Tu r n i n g k n o b 7 s e t s t h e c o o k i n g
temperature, which is shown on the
relevant display.
6 • ENTERING AND SAVING A PROGRAM
OPERATIONS
6.5A • SET THE TIME OF CYCLE 1
The time display shows [InF].
Turn knob 9:
to the right to set the cooking time;
to the left to set infinite time, [InF] thus
utilizing the first cycle as preheating.
Or
6.5B • SET THE CORE PROBE
FOR CYCLE 1
Refer to
6.6 • SELECT CYCLE 2
AND THE FOLLOWING ONES
(UP TO 9 CYCLES)
Press the cycle key 5, the cycles display 8
shows [C 2]. Now go back to paragraph 6.3
to continue with the setting. Repeat the
sequence for further phases if required.
6.7 • SAVING THE PROGRAM
Press the cycles key 5 or wait 10 seconds to
save the settings automatically or, without
waiting, press key 15 to start multi-phase
cooking.
11
90024720rev00
Ò S e t t i n g t h e c o r e p r o b e Ó
. Page 13.