Install The Phoenix 200 Antenna (If Applicable); Enable Switch - Raven SmarTrax Installation Manual

Chapter 3

Install the Phoenix 200 Antenna (If Applicable)

Phoenix 200 Antenna Installed
FIGURE 16.
GPS Roof
Connection
Install the Phoenix 200 antenna (P/N 063-0172-719) on the existing mounting plate on the cab roof.
1.
Connect the Phoenix 200 to Case harness cable (P/N 115-0172-019) between the antenna and the GPS
2.
roof connection.
Connect the CASE GPS connection and the DGPS IN connection from the node harness (P/N 115-4001-
3.
127) cable together.
Reassemble the instructional seat.
4.

Enable Switch

Enable Switch.
FIGURE 17.
A factory-installed switch is installed on the floor of the machine's cab. Use this enable switch to engage and
disengage the SmarTrax system after installation and calibration of the system is complete. Refer to the
18
Case IH Patriot 4430 and Titan XX30 Series - Steering Ready, Model Year 2012 SmarTrax™ Installation Manual