VM Motori MR 700 Instruction Manual page 86

START-UP
- Engines on pallets
Remove the covers and protective
elements applied to the engine open-
ings (for instance, air suction ducts
or turbocharger air inlet, exhaust gas
ducts or turbocharger guard).
Check there is no damage to the ex-
ternal engine components; make any
necessary repairs.
Clean the throats of the metal belt
pulleys, using a suitable solvent.
Install the service belts
Check the rubber tubes and mani-
folds are in good condition, and
check the tightening of the relative
fixing clips; if they are damaged,
replace them.
All surfaces and components pro-
tected with "FL MECAFLUID / P118 V"
protective oil can be cleaned with a
suitable solvent.
Check the level of the fluids: engine
oil and coolant. Top up if necessary.
- Engines on vehicles
Check there is no damage to the ex-
ternal engine components; make any
necessary repairs.
Clean the throats of the metal belt
pulleys, using a suitable solvent.
Install the service belts.
Check the rubber tubes and mani-
folds are in good condition, and
check the tightening of the relative
fixing clips; if they are damaged,
replace them.
Ed. 3 - 2012_11
All surfaces and components pro-
tected with "FL MECAFLUID / P118 V"
protective oil can be cleaned with a
suitable solvent.
Check the level of the fluids: engine
oil and coolant. Top up if necessary.
Nothing needs to be done to remove
the internal protection (either for engi-
nes on pallets or on vehicles).
4
MR 700
English