VM Motori MR 700 Instruction Manual page 104

ENGINE OIL CHANGE
Follow the procedure below.
1 -Turn off the engine and remove the
ignition key.
2 -Let the engine cool down adequately to
avoid being burnt.
3 -Prepare a container of appropriate
capacity. As for the oil quantity, see "Spe-
cifications".
4 -Unscrew the load plug (M).
5 -Unscrew the plug (Q).
6 -Insert the pump (R) and screw it to
pipe.
7 -Operate manually the pump to transfer
all the oil into the container.
8 -Pour the new oil until it reaches the
correct level on the dipstick (see "Engine
oil level control")
9 -Disconnect the pump.
10 -Screw again the plug (Q).
Warning - Caution
In the event of oil leaks, check the le-
vel periodically to evaluate the extent
of the leak. If the amount is excessive,
contact one of the manufacturer's
authorised service centres.
Ed. 3 - 2012_11
load plug (M)
pump (R)
11 -Screw again the load plug (M).
12 -Start the engine and bring it to the
operating temperature (70÷80 °C).
13 -Check for any oil leaks
14 -Turn off the engine and check the oil
level (see "Engine oil level control").
Important
Do not throw the oil in the environ-
ment but carry out its disposal in
compliance with legislation in force in
the country where it is used. Use the
oils and lubricators recommended by
the manufacturer (see "Recommen-
ded lubricants").
4
MR 700
plug (Q)
English