VM Motori MR 700 Instruction Manual page 105

COOLANT REPLACEMENT
Follow the procedure below.
1 -Start the engine and run it at minimum
speed for a few minutes. The cooling
circuit reaches the operating pressure.
2 -Turn off the engine and remove the
ignition key.
3 -Let the engine cool down adequately to
avoid being burnt.
4 -Prepare a container of appropriate
capacity. As for the liquid quantity, see
"Specifications".
5 -Open the cock (S).
6 -Unscrew the plug (S1).
7 -Let the liquid flow into the container.
8 -Close the cock (S).
9 -Screw again the plug (S1).
10 -Carry out the same operation on the
cock (S2) as well.
11-Unscrew the plug (P).
12-Pour in the new liquid. The liquid level
should be included between the mini-
mum and maximum notches printed on
the expansion chamber. As for the liquid
quantity and type, see "Specifications".
13 -Screw again the plug (P).
14 -Turn the engine on and leave it run-
ning at minimum speed for a few minutes
until it reaches working speed (70÷80°C).
15 -Turn off the engine and let it cool
down properly.
16 -Check the coolant level and, if neces-
sary, carry out topping-up (see "Engine
coolant level check").
Ed. 3 - 2012_11
cock (S)
cock (S2)
Important
Do not throw away any polluting
material in the environment. Carry out
their disposal in compliance with the
relevant legislation in force.
4
MR 700
plug (S1)
load plug (P)
English