Raven SmarTrax Installation Manual page 25

Node Mounting
FIGURE 4.
To Install the Node:
Select the preferred location for the node. See the recommendations for choosing a mounting location
1.
above.
Using the mounting tabs on the node as a template, mark and pre-drill holes in the floor. Using bolts or
2.
screws (not supplied), secure the node in position.
Connect the large, round connectors on the node adapter cable (P/N 115-4001-007) and SmarTrax console
3.
cable harness (P/N 115-0171-775).
Connect the large, rectangular connectors to the SmarTrax node.
4.
Connect your receiver or source of DGPS to the connector labeled 'DGPS' on the node adapter cable.
5.
Connect the console providing machine guidance to the remaining small, round connector.
6.
Connect the 4-pin deutsch plug to the vehicles CANbus system.
7.
Route the power leads to the vehicle's battery and connect.
8.
Connect the red power leads on the positive battery terminal.
a.
Connect the black power leads on the negative battery terminal.
b.
Manual No. 016-0190-083
Direction Arrows
Any two arrows must be
parallel with level ground
Mounting Tabs
Wiring & Electrical Connections
21