Table of Contents
Advertisement
Welding
Voltage Control
LCD Synergic
Inert Gas
Multi-Function
Control
Regulator
Adjustment/Selector
Knob
Inert Gas
Hose
120V Adapter
Cord
Electrode Holder
MIG Torch
Ground Cable
and Cable
and Clamp
MIG TORCH
The welding wire is driven through the welding cable and torch to the work piece. It is attached to the
drive system. The trigger activates the drive motor.
POWER CORD AND PLUG
Plug this unit into a 230V, 50 amp circuit breaker power supply when operating on 230V. If running
on 120V power using the supplied 120V power cord adapter, plug this unit into a 120V, 20 amp
circuit breaker power supply.
INERT GAS REGULATOR AND HOSE
The Inert Gas Regulator installs on the shielding gas cylinder for MIG welding with solid wires. The
regulator controls the compressed gas and allows you to adjust the flow rate of the gas. The gas hose
connects to the regulator/flow gauge and delivers the shielding gas from the shielding gas bottle to the
welder.
MULTI-FUNCTION ADJUSTMENT/SELECTOR KNOB
The Multi-Function Adjustment/Selector Knob is used by the operator to interact with the LCD Synergic
Control. It is used to selection and adjustment of welding processes, materials, and selections within the
LCD Synergic Control screen.
LCD SYNERGIC CONTROL
The LCD Synergic Control sets and operates the welder based on selections the operator makes in weld
process and material selections.
WELDING VOLTAGE CONTROL
The voltage control allows the operator to make manual voltage adjustments to the LCD Synergic
programming.
GROUND CABLE AND CLAMP
The ground cable and clamp are attached to the work piece to complete the circuit allowing the flow of
current needed to weld.
ELECTRODE HOLDER AND CABLE
The Electrode Holder holds the stick welding electrode. The cable most often connects to the Positive (+)
weld output connection for stick welding.
Page
8
of 45
1812367-12
Advertisement
Table of Contents
