Table of Contents
Advertisement
ii. Make sure the proper groove on the drive roller is in place for the wire installed. If
not, change the drive roller as described in INSTALL THE WIRE ROLLER
above.
iii. Remove the packaging from the spool of wire and then identify the leading end
of the wire secured on the edge of the spool. DO NOT UNHOOK IT AT THIS
TIME.
Contact
Tip
Flux Core
Nozzle
iv. Place the spool on the spool hub so the wire will pull off the bottom of the spool.
The welding wire should always come off the bottom of the spool into the drive
mechanism (Figure 4).
v. The welder can use either 4 inch or 8 inch spools. See Figure 5 for additional
reference. The wing nut controls the tension on the spool.
MIG
Nozzle
Figure 3
Figure 4
Page
11
of 45
1812367-12
Advertisement
Table of Contents
