Matco Tools MP200DVILCD Owner's Manual page 22

KNOB. Wire Speed will no longer be highlighted, but will have a
box around it. Turn the MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB to go through other options.
Press the MULTI-FUNCTION ADJUSTMENT/SELECTION
KNOB to adjust the highlighted Option.
iii. MIG Al – Choose this option if you are MIG welding Aluminum
1. Use the MULTI-FUNCTION ADJUSTMENT/SELECTION KNOB to
select if you are using a spool gun. Press the MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB to confirm your selection.
a. No Spool Gun Used:
i. Connect the Weld Power Cable (See Figure 8 or follow
the onscreen visual) to the Positive (+) Weld Output
Connection. Press the MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB to confirm your
selection.
ii. Use the MULTI-FUNCTION ADJUSTMENT/SELECTION
KNOB to select your wire diameter. Press the
MULTI-FUNCTION ADJUSTMENT/SELECTION KNOB
to confirm your selection. (.040 or .045 are ran the
same). Only .045 wire diameter is recommended when
not using a spool gun. To run other wire sizes of
aluminum wire without a spool gun, use the MIG
MANUAL setup.
iii. Use the MULTI-FUNCTION ADJUSTMENT/SELECTION
KNOB to select the thickness of material to be welded.
Press the MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB to confirm your
selection.
iv. This machine is now set to weld.
1. Use the MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB to fine tune
wire feed speed.
2. Use the VOLTAGE CONTROL KNOB to fine
turn voltage.
v. You can adjust other parameters:
1. Press the MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB. Wire
Speed will no longer be highlighted, but will
have a box around it. Turn the
MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB to go
through other options. Press the
MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB to adjust
the highlighted Option.
Page 22 of 45
1812367-12