Table of Contents
Advertisement
MIG
Socket
5-Pin Trigger
Receptacle
Positive (+)
Weld Output
Connection
3. Insert the back end of the MIG torch into the MIG socket on the front of your machine (Figure 8).
Make certain to completely slide the torch all the way in. Slightly twist to assist with pushing the
torch to the back of the receptacle. The retaining bolt can then be tightened, making certain the
bolt sets down into the retaining groove on the back of the MIG torch.
4. Connect the 5-Pin trigger connection on the MIG torch to the 5-Pin trigger receptacle on the front
panel (Figure 8).
5. Connect the ground cable to the negative (-) weld output connection for MIG welding. If welding
with self-shielded flux core, connect the ground cable to the positive (+) weld output connection
and move the Weld Power Cable to the negative (-) weld output connection.
6. Follow the Wire Feed Welding Set-up instructions in the Operating section.
SPOOL GUN ASSEMBLY
1. This unit is set-up to accept an Optional Spool gun.
2. The Optional Spool Gun has three connection points at the back of the spool gun (Figure 9).
1) The gas connection is a slide-on quick connector.
2) The weld power connection has a round ring connection.
3) The trigger connection is the 5-Pin snap-on connector.
Figure 8
Page
16
of 45
Negative (-)
Weld Output
Connection
Weld Power
Cable
1812367-12
Advertisement
Table of Contents
