Table of Contents
Advertisement
d. Welding position
Flat position is the easiest of the welding positions and is most commonly used. It is best
if you can weld in the flat position if at all possible as good results are easier to achieve.
Flat Position
The horizontal position is performed very much the same as the flat weld except that the
angle is different such that the electrode, and therefore the arc force, is directed more
toward the metal above the weld joint. This more direct angle helps prevent the weld
puddle from running downward while still allowing slow enough travel speed to achieve
good penetration. A good starting point for your electrode angle is about 30 degrees
DOWN from being perpendicular to the work piece.
e. Judge the good weld bead
When the trick of establishing and holding an arc has been learned, the next step is
learning how to run a good bead. The first attempts in practice will probably fall short of
acceptable weld beads. Too long of an arc will be held or the travel speed will vary from
slow to fast (see following).
A. Weld speed is too fast.
B. Weld speed is too slow.
C. Arc is too long.
D. Ideal weld.
A solid weld bead requires that the electrode be moved slowly and steadily along the weld
seam. Moving the electrode rapidly or erratically will prevent proper fusion or create a lumpy,
uneven bead.
f. Finish the bead
As the coating on the outside of the electrode burns off, it forms an envelope of
protective gases around the weld. This prevents air from reaching the molten metal and
creating an undesirable chemical reaction. The burning coating, however, forms slag.
The slag formation appears as an accumulation of dirty metal scale on the finished weld.
Slag should be removed by using a chipping hammer.
Page
37
of 45
Horizontal Position
1812367-12
Advertisement
Table of Contents
