Matco Tools MP200DVILCD Owner's Manual page 23

b. With a spool gun:
iv. MIG CuSi – Choose this option if you are welding Copper & Silicon blend wires
such as Silicon Bronze.
1. Connect the Weld Power Cable (See Figure 8 or follow the onscreen
visual) to the Positive (+) Weld Output Connection. Press the
MULTI-FUNCTION ADJUSTMENT/SELECTION KNOB to confirm your
selection.
2. Use the MULTI-FUNCTION ADJUSTMENT/SELECTION KNOB to
select your wire diameter. Press the MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB to confirm your selection.
i. Use the MULTI-FUNCTION ADJUSTMENT/SELECTION
KNOB to select the wire alloy to be used.
ii. Connect the Weld Power Cable (See Figure 8 or follow
the onscreen visual) to the Positive (+) Weld Output
Connection. Press the MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB to confirm your
selection.
iii. Use the MULTI-FUNCTION ADJUSTMENT/SELECTION
KNOB to select the thickness of wire you are using.
Press the MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB to confirm your
selection.
iv. Use the MULTI-FUNCTION ADJUSTMENT/SELECTION
KNOB to select the thickness of material to be welded.
Press the MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB to confirm your
selection.
v. This machine is now set to weld.
1. Use the MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB to fine tune
wire feed speed.
2. Use the VOLTAGE CONTROL KNOB to fine
turn voltage.
vi. You can adjust other parameters:
1. Press the MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB. Wire
Speed will no longer be highlighted, but will
have a box around it. Turn the
MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB to go to
other options. Press the MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB to adjust
the highlighted Option.
Page 23 of 45
1812367-12