Table of Contents
Advertisement
Installation Guide Cont'd
UV Indicator Light
No Light: Unit is not active or no power connected
Blue Light: Unit is active and sterilizing water
Blinking Red Light: Unit overheating - Allow time to cool down
Steady Red Light: Unit malfuntion - Call Acuva for support (1.604.431.9241)
Optional Smart-faucet Installation
If you have opted install the Acuva Smart Faucet with the provided 3/8" Tee
after the UV device (or with a ½"x ½" x 3/8" Tee with shut-off valve fitting
and 3/8"-1/4"OD Tube reducing union), use a short length of 3/8" tube to
connect the Tee with 3/8"-1/4"OD Tube reducing union (or for single faucet
applications, only the 3/8"-1/4"OD Tube reducing union), to connect a length
of ¼" PE tube to the drinking water faucet stem, and add the provided flow
restrictor to the ¼" line.
1. Drill a 3/4" hole into the counter top where the Smart Faucet will be
inserted.
2. Thread the faucet power cord into the 3/4" hole and insert the faucet
stem into the hole.
3. Thread the faucet power cord through the plastic spacer under the
counter to ensure that the cord is not pinched against the counter when
the faucet is fastened into place, making sure that the spacer's O-ring
seal is facing up to seal against the counter.
4. Add the plastic threaded fastener to the faucet stem and tighten the
fastener against the spacer to secure the faucet into place. Make sure
that the faucet is positioned properly as required before tightening the
fastener.
5. To connect the ¼" water line to the faucet stem, slip the hex nut onto the
tube, followed by the plastic ferrule and plastic tube support. Press the
tube end and ferrule to the bottom of the faucet stem and tighten the hex
nut by hand, then tighten the nut with a wrench while being careful not to
over-tighten.
Advanced UV-LED Water Purification |
acuvatech.com
Acuva Arrow UV-LED Water Purifier
O W N E R ' S P R O D U C T M A N U A L
Page 8
Advertisement
Table of Contents
