Table of Contents
Advertisement
Installation Guide Cont'd
Final Installation Steps
1. Connect the power supply cord to the UV chamber DC power plug.
2. Activate the cold-water pressure in the plumbing system.
3. Open the fitting valves
4. Open the downstream faucet(s) or water appliances. (When water is
flowing, the blue light on the device will come on steady which indicates
the water purification is in progress as seen in Figure 6)
5. Keep the faucet on to flush the system for 3-5 minutes to release all the
air pocket and bubbles and any loose granulated carbon form the pre-
filter and the water flows smoothly.
6. Once all the bubbles are released, turn off the faucet and the device will
automatically go into standby mode. At this point, the device is ready for
regular use.
Maintenance
The Acuva UV-LED Water Purification Systems are designed to give years
of trouble-free service. Using state-of-the-art long-life UV-LEDs, there are no
mercury bulbs to replace and dispose annually. However, there are some simple
tasks that should be performed to ensure continued trouble-free operation.
Regular Maintenance
1. Check that none of the connectors are leaking annually.
2. Replace the inline 5-micron carbon filter every 2 years.
Winterizing
WARNING
Failure to properly winterize the device before it is exposed to freezing
temperatures can lead to damage and water leakage.
To prevent freezing, pump a non-toxic antifreeze into the water system.
Open the point of use faucet connected to the Acuva device and
continue to pump non-toxic antifreeze until you see the antifreeze
coming out of the faucet. In the spring, remember to flush with fresh
water to clear the antifreeze before drinking.
Advanced UV-LED Water Purification |
acuvatech.com
Acuva Arrow UV-LED Water Purifier
O W N E R ' S P R O D U C T M A N U A L
Page 9
Advertisement
Table of Contents
