Table of Contents
Advertisement
Installation Guide
Mounting the Unit
1. Engage the spring-loaded mechanism by hooking the clip onto the
bottom edge of the din rail and adding slight pressure upwards.
2. As bottom portion engages, tilt the upper hook towards the din rail.
3. Release the spring mechanism once the unit is mounted on the rail.
UV Indicator Light
No Light: Unit is not active or no power connected
Blue Light: Unit is active and sterilizing water
Green Light: At the Initial start-up, green light turns ON for 30 sec meaning
the unit is properly powered and the flow switch/smart faucet is properly
plugged to the unit. The Eco unit will perform a self clean if the unit is
powered, but not used for 12 hrs. During the self clean mode, the green
light turns on for 30 sec.
Note: If there is an issue the indicator light will turn red or yellow and the
trouble shooting table in section 5 should be consulted
Conditioning and Powering the Unit
1. Once the Device is connected to the cold waterline, allow water to flow
through the system for 1-2 minutes until the bubbles are released from
the line. During this time, make sure all the connections are tight and sealed.
2. Connect the DC power source or AC to DC power converter to the Eco unit.
3. Turn on the faucet, a steady blue light should appear on the device which
indicates the water purification is in progress
4. Turn off the faucet and the device will automatically go into standby mode.
5. At this point, the device is ready for regular use.
Advanced UV-LED Water Purification |
acuvatech.com
Acuva Eco NX-Silver
O W N E R ' S P R O D U C T M A N U A L
Page 7
Advertisement
Table of Contents
