Mounting The Unit; Uv Indicator Light; Conditioning And Powering The Unit - Acuva Arrow 5 Owner's Product Manual

Uv-led water purifier

Hide thumbs Also See for Arrow 5:

Table of Contents

Installation Guide Cont'd

Mounting the Unit

1. Engage the spring-loaded mechanism by hooking the clip onto the

bottom edge of the din rail and adding slight pressure upwards.

2. As bottom portion engages, tilt the upper hook towards the din rail.

3. Release the spring mechanism once the unit is mounted on the rail.

No Light: Unit is not active or no power connected

Blue Light: Unit is active and sterilizing water

Green Light: At the Initial start-up, green light turns ON on the unit for 30

sec meaning the unit is properly powered and the flow switch/smart faucet

is properly plugged to the unit. The Arrow unit will perform a self clean if

the unit is powered, but not used for 12 hrs. During the self clean mode, the

green light turns on for 30 sec.

Note: If there is an issue the indicator light will turn red or yellow and the trouble shooting

table in section 5 should be consulted

1. Once the Device is connected to the cold waterline, allow water to flow

through the system for 1-2 minutes until the bubbles are released from

the line. During this time, make sure all the connections are tight and sealed.

2. Connect the DC power source or AC to DC power converter to the

Arrow unit

3. Turn on the faucet, a steady blue light should appear on the device

which indicates the water purification is in progress

4. Turn off the faucet and the device will automatically go into standby mode.

5. At this point, the device is ready for regular use.

Advanced UV-LED Water Purification |

acuvatech.com

Acuva's Arrow 5 UV-LED Water Purifier

O W N E R ' S P R O D U C T M A N U A L

Page 7

Table of Contents