Table of Contents
Advertisement
Installation Guide
Mounting the Unit
1. Engage the spring-loaded mechanism of the mounting clips on the device
by hooking the clip onto the bottom edge of the DIN-rail and applying
slight pressure upwards.
2. As bottom portion engages, tilt the upper hook towards the DIN-rail.
3. Release the spring mechanism once the unit is mounted on the rail.
Spring-Loaded
Mechanism
Conditioning and Powering the Unit
1. Once the device is connected to the cold-water line, allow water to flow
through the system for 1-2 minutes until any bubbles are released from
the line. During this time, ensure all connections are tight and sealed.
2. Connect the DC power source or AC to DC power adapter to the device.
Hand-tighten the nut to the threaded jack to secure it.
3. If there is no water flow on powering up, the Acuva logo should glow
green for 30 seconds.
4. Turn on the faucet. The logo will glow blue which indicates the water
purification is in progress. If the smart faucet is installed, its base will glow
blue as well.
5. Turn off the faucet and the device will automatically go into standby mode.
Indicator Light
The Acuva logo lights up to indicate various modes of use.
No Light: The device is idle or no power is connected.
Blue Light: The device is active and sterilizing water.
Green Light: The device is undergoing its self-cleaning protocol. This 30
second protocol occurs at start up as well as after every 12 hours of idle
time and can be safely interrupted to dispense water.
Note: If there is a fault, the indicator light will turn red or yellow. Please consult the
Troubleshooting section.
Advanced UV-LED Water Purification |
acuvatech.com
Acuva Eco NX-Silver
O W N E R ' S P R O D U C T M A N U A L
Page 8
Advertisement
Table of Contents
