Replacing The Dispensing Lever; Replacing The Soda Lever - Cornelius SFV1 Installation And Service Manual

5. Position the new pull-type solenoid (Fig. 32/3) on the valve head (Fig. 32/2).
6. Attach the pull-type solenoid (Fig. 32/3) by pushing the pull-type solenoid (Fig. 32/3) into the
valve head (Fig. 32/2).
The pull-type solenoid must audibly engage.
7. Attach the cover (Fig. 32/1) of the pull-type solenoid (Fig. 32/3).
Finishing tasks
1. Mount the dispensing valve, see chapter 4.1.
6.8

Replacing the dispensing lever

Prerequisites
The dispensing valve has been removed.
Spare parts
SFV1 dosing lever: Lever (sanitary)
1. Remove the base plate (Fig. 33/3) of the dispensing valve by pushing the two side tabs (Fig.
33/1) apart and carefully pulling the base plate (Fig. 33/3) forwards and downwards from the
valve body (Fig. 33/2).
2. Pull the dosing lever (Fig. 34/1) upwards out of the base plate (Fig. 34/2).
3. Insert the new dosing lever (Fig. 34/1) into the base plate (Fig. 34/2) from above.
4. Fasten the base plate (Fig. 33/3) of the dispensing valve by inserting the base plate (Fig. 33/
3) with the rear tabs into the valve body (Fig. 33/2) and carefully pushing the base plate (Fig.
33/3) upwards until the side tabs (Fig. 33/1) engage.
Finishing tasks
1. Mount the dispensing valve, see chapter 4.1.
6.9

Replacing the soda lever

Prerequisites
The dispensing valve has been removed.
Spare parts
Soda lever
1. Remove the soda lever, see chapter 4.4.
2. Mount the soda lever, see chapter 4.3.
Finishing tasks
1. Mount the dispensing valve, see chapter 4.1.
Installation and service manual Dispensing valve
SFV1
20
References
see chapter 4.2
ID/reference
560003193
References
see chapter 4.2
ID/reference
3297
1
3
Fig. 32
Qty/amount Comment
1
1
3
Fig. 33 Example graphic
2
Fig. 34 Example graphic
Qty/amount Comment
1
Cornelius Deutschland GmbH
Document no. TD2005100
Version 15/03/2019, Index 0
Repairs
2
2
1