Hardware; Vario Unit Settings - Te Compensation - LXNAV LX90 Series User Manual

Rev #23
Glider ballast can be entered as:
overload factor, which is defined as:
•
overload
Load, which is entered in kg/m
•
Weight of water ballast. If this option is used the weights of the glider and pilot
•
must be entered. Refer to Chapters 0 and 5.1.2 for more details of how to enter glider
and pilot weights.

5.1.11 Hardware*

Use this menu to define hardware properties such as total energy compensation, vario
indicators layout, compass calibration, FLARM module settings, AHRS settings, Wi-fi module,
NMEA output and data which will be exchanged between the rear and front display units.
Some items may be greyed out when the selected option is not available.
5.1.11.1 Vario Unit Settings – TE Compensation*
All settings in this menu are related to the glider and thus they do not depend on profile
selection. In this manual dialogue description is given for firmware version 5.0 or higher
with V5, V8, V9, V80 variometers. If an older version or older Variometer is being used,
please refer to a previous version of this manual.
Total energy compensation, temperature offset, airspeed offset, and digital inputs are setup
in this menu.
Version 7.10
Empty . glider . weight
=
REFERENCE
2 or lb/ft 2 .
Pilot . weight Water
+ +
. glider . weight
December 2019
. ballast