MIMAKI UCJV300 Series Operation Manual page 62

Chapter 2 Printing
15
Check how far the medium was pulled out.
• Pull the front edge of the medium gently at several points to confirm that the medium was pulled
out by the same amount.
16
Lower the clamp lever.
17
Secure the medium in the media holder.
• Do not use the media holder when printing on thicker media.
• Do not use the media holder when cutting media.
18
Press , then select "Roll".
• This starts media width detection.
• If the setting for [Machine Setup] > [Media Detect] > [Detection Type] is "MANUAL", the area for
printing must be determined manually.
• If the setting for [Machine Setup] > [Media Detect] > [Media Remain] is "ON", the media length
input screen will be displayed.
• A notification reading "Media Set Position R" will appear if the medium is too far to the
right of the specified position. Reload the media.
19
Enter the number of pinch rollers being used.
• If the setting for [Machine Setup] > [Media Detect] > [Use PR Number Query] is "OFF", the screen
for entering the number of pinch rollers will be displayed.
Media holder
62