Nozzle Check Menu; Nozzle Check Menu List - MIMAKI UCJV300 Series Operation Manual

Chapter 5 Settings

5.4 Nozzle Check Menu

This is used to check if the nozzles are clogged before printing starts. Sets whether to perform maintenance
automatically if nozzle clogging is detected.
l Nozzle Check Menu Screen
LOCAL
MENU

Nozzle Check Menu List

Item
Printing Check
Check Interval
Length 0.1 m to 30.0
m to 50.0 m
File 1 to 30 to 100
Action
Cleaning Soft/Normal/
Retry Count 0 to 3 times
Auto Nozzle
Recovery
Judgment
*2
Condition
*1. The default settings are shown underlined.
*2. Nozzle recovery is not available for certain print conditions.
• If an error occurs during the nozzle check operation, the next print will be automatically stopped,
and [Printing Check] will be set to "OFF". Clear the error, then set [Printing Check] to "ON"
manually.
MENU
SETUP
MAINTENANCE
width:1340mm
MACHINE SETTUP
NOZZLE CHECK
INFORMATION
three
TEST PRINT
<<
REMOTE
CLEANING
times
*1
Setting
ON/OFF Performs nozzle clogging detection before printing starts.
- Sets the nozzle clogging detection timing.
Performs nozzle clogging detection after the length set is reached
and before the next print starts.
Performs nozzle clogging detection for each number of files set.
files
- Performs nozzle recovery (cleaning followed by nozzle checking) if
"nozzle clogging" is detected.
Sets the cleaning type.
Hard
Performs nozzle recovery (cleaning followed by nozzle checking) for
the specified number of times.
ON/OFF Performs nozzle recovery automatically if "nozzle clogging" is
detected.
See below if you wish to perform nozzle recovery manually.
"Registering nozzle recovery"(P. 114)
1 to 64 Set the number of nozzles to be detected as clogged before "nozzle
nozzles clogging" is detected. Up to 16 nozzles per row can be set.
The next print will not start if "nozzle clogging" is detected during
continuous printing.
NOZZLE CHECK
Printing Check
>
NOZZLE RECOVERY
>
Judgement Condition
>
>
>
>>
Details
122
OFF
OFF
>