Connecting A Pc To The Product; Using A Usb 2.0 Interface Cable; Using A Lan Cable - MIMAKI UCJV300 Series Operation Manual

Chapter 1 Before Using This Product

1.3 Connecting a PC to the Product

Using a USB 2.0 Interface Cable

Connect a PC to this product using a USB 2.0 interface cable.
• Do not unplug the cable while data is being transferred.
• Use RIP software that supports the USB 2.0 interface.
• If your PC does not have a USB 2.0 port, contact your local dealer or our service office.
USB 2.0 Interface Precautions
l When connecting more than one UCJV300 Series, 150 Series to a PC
The UCJV300 Series, 150 Series may not be correctly recognized.
If the PC has more than one USB port, try connecting to a different USB port to check whether the product is
correctly recognized. If the product is still unrecognized even when connected to a different USB port, use a
commercially-available USB 2.0 active repeater cable.
l USB high-speed mode peripheral devices
It may not be possible to recognize USB peripheral devices if USB high-speed mode peripheral devices
(e.g., USB memory, USB HDD devices) are connected to the PC to which the product is connected. Data
transfer speeds to this product may be reduced if external USB hard disk drives or similar devices are
connected. This may cause the carriage to temporarily stop at the left-hand or right-hand end during printing.
l Unplugging USB memory devices
When unplugging USB memory devices from the PC to which this product is connected, use "Stop" in
"Safely removing hardware" before unplugging. Otherwise, an [ERROR 10 command error] will occur.

Using a LAN Cable

Connect a PC to this product using a LAN cable. Insert a LAN cable until it engages with a click.
• Do not unplug the cable while data is being transferred.
USB or LAN
36