MIMAKI UCJV300 Series Operation Manual page 177

Error Message
number
516 Media Set Position R
519 NEGATIVE P.SENSOR
521 CHECK JOINT
SENSOR
522 CUT HOME POSITION
523 CHECK PR SENSOR
525 Wrong Ionizer
526 Ionizer Ion Level
527 Ionizer Condition
528 Pump Motor Sensor
549 LEnc. Count DIO
551 HDC DIO LENC count
607 Replace Cap Absorber
608 Wrong Ink IC
61A InkOverflow
61B Ink feed
61D NEGATIVE P.
NotEnough
Cause
• The media was loaded
outside the range of valid
positions.
• Negative pressure sensor
automatic recognition failed.
• A failure occurred while
connecting the cutter head
and the connecting unit.
• The cutter head could not be
moved due to a connection
failure between the cutter
head and the connecting unit.
• The pinch roller position
detection failed.
• The ionizer internal circuit is
defective, or an abnormal
discharge occurred.
• The amount of generated
ions was reduced by fouling
and abrasion of the electrode
needle.
• Ambient conditions may
cause ions to be absorbed by
metals in the vicinity and
affect discharge capability.
• A problem was detected with
the pump motor.
• A problem was detected with
the linear scale wiring to the
DIO PCB.
• A problem was detected with
the HDC and DIO board
encoder values.
• The capping count exceeded
the preset value.
• A problem was detected with
the ink IC chip information.
• The sub tank float sensor
detected the limit.
• A failure occurred while
supplying ink to the sub tank.
• The required negative
pressure cannot be
maintained. (On the positive
side)
177
Chapter 7 Troubleshooting
Corrective action
1. Check the media loading position.
"Loading the Media"(P. 59)
2. Clean the media width sensor.
"Media Sensor Cleaning"(P. 141)
• Turn off the power on the machine and
turn it on after a while.
the Power"(P. 34)
• Refer to the instruction manual for the
ionizer and clean the electrodes.
• Remove any conductors or discharge
devices close to the ionizer.
• Turn off the power on the machine and
turn it on after a while.
the Power"(P. 34)
• Replace and clean the cap absorber,
then reset the count.
Replacement"(P. 147)
1. Check to confirm that the IC chip was
inserted correctly.
2. Turn off the power on the machine and
turn it on after a while.
the Power"(P. 34)
3. Replace with new ink.
• Execute [MAINTENANCE] > [Overflow].
• Turn off the power on the machine and
turn it on after a while.
the Power"(P. 34)
"Turning Off
"Turning Off
"Cap Absorber
"Turning Off
"Turning Off
7