Beurer DM 49 Instructions For Use Manual page 8

There are two different ways to access the menu from which you can
adjust the settings:
• Before initial use and after each time you replace the battery:
When you insert new batteries into the device, the display lights up and
the announcement described in the "6.1 Inserting the batteries" section
sounds in the relevant pre-set language. Press and hold the memory
button for approx. 5 seconds.
• If the batteries have already been inserted:
When the device is in standby mode, press the START/STOP button
(date and time is displayed permanently).
All display segments light up briefly; immediately following this, the
announcement sounds in the language set by you. Press and hold
the memory button for approx. 5 seconds.
In this menu you can adjust the following settings in succession:
Date Time ➔ Language ➔ Volume
➔
The year flashes on the display.
• Set the year with the function
buttons and confirm with the
memory button .
• Next, set the month, day, hour
and minute in the same way and
confirm each setting with the
memory button .
The language will flash on the
display .
• You can select the following lan-
guages with the function buttons
:
= English
= Spanish
= Russian
= Greek
= Language off
Confirm your selection with
the memory button .
= Language off means
that there is no voice output
and therefore no acoustic
playback.
8
Voice output
The device is ready for use.
You may start measuring.
English
Español
Русский
Ελληνικά