Zoom X3 Adsl Modem Model 5560 Setup - Edgetech 4200 User Hardware Manual

$exit
The captured telnet session is the following:
$modify dsl config defaultsgmt
Set Done
$modify dsl config bitswap enable
Set Done
$commit
Set Done
$get dsl config
Whip ..................: Disable............. Trellis coding ............. : Disable
Conn Standard .........: -................... Max Down Rate .............. : 0xff
ExpExchSeq ............: Expanded............ Framing structure .......... : Framing-3
TxAttenuation<dB> .....: 0................... Coding Gain ................ : Auto
TxBinAdjust ...........: Disable............. RxBinAdjust ................ : Disable
TxStartBin ............: 6................... TxEndBin ................... : 31
RxStartBin ............: 32.................. RxEndBin ................... : 255
Fast Restrain .........: Enable.............. Esc Fast Retrain ........... : Disable
MaxBits/bin On Rx .....: 15.................. Bit Swap ................... : Enable
Dual Latency ..........: Disable............. Pmode ...................... : Enable
Pilot Request .........: Enable.............. Last Failed Status ......... : 0x0
Oper Status ...........: Statup HShake....... Startup Progress ........... 0xa0
AC Mode item ..........: fbm................. AC Ttr R Offset ............ : 0
AC Pilot Request ......: Enable.............. EC Fdm Mode ................ : FDM
Pwr Mgmt Mode .........L2L3NotAllwd.......... Profile .................... : Main
Adv Capability ........: Annex A
UpstreamBitswap .......: Enable.............. Memory Mode ................ : Disabled
UpstreamLatency .......: -................... DownstreamSteamLatency ..... : -
MaxSNR Margin .........: Disabled............ SRA ........................ : Disabled
Defaults ..............: G.dmt............... Logging .................... : Disabled
$_
After these settings have been saved to flash memory, the modem configuration is complete.
A.2.4

Zoom X3 ADSL Modem Model 5560 Setup

To set up the Zoom X3 ADSL Modem Model 5660:
1. Open your web browser and enter http://10.0.0.2 or http://192.9.0.22 to connect to the modem.
2. Login with username = admin and password = zoomadsl.
The Basic Setup page opens:
Response: none, telnet disconnects
A-13