Zoom X5 Adsl Modem Model 5654 Setup-Telnet-Only Accessible Configuration - Edgetech 4200 User Hardware Manual

$exit
The captured telnet session is the following:
$modify dsl config autosensegdmtfirst
Set Done
$modify dsl config bitswap enable
Set Done
$commit
Set Done
$get dsl config
Whip ................ : Disable ................ Annex Type ........... : Annex A
Standard ............ : Autosense GDMT first ... Trellis coding ....... : Enable
ExpExchSeq .......... : Expanded ............... Framing structure .... : Framing-3
TxAttenuation(dB) ... : 0 ...................... Coding Gain .......... : Auto
TxBinAdjust ......... : Enable ................. RxBinAdjust .......... : Disable
TxStartBin .......... : 6 ...................... TxEndBin ............. : 31
RxStartBin .......... : 32 ..................... RxEndBin ............. : 255
Fast Retrain ........ : Disable ................ Esc Fast Retrain ..... : Disable
MaxBits/bin On Rx ... : 14 ..................... Bit Swap ............. : Enable
Dual Latency ........ : Enable ................. Pmode ................ : Enable
Pilot Request ....... : Enable ................. Last Failed Status ... : 0x0
Oper Status ......... : Showtime/Data .......... Startup Progress ..... : 0xad
AC Mode item ........ : dbm .................... AC Ttr R Offset ...... : 42
AC Pilot Request .... : Disable ................ EC Fdm Mode .......... : FDM
Max Down Rate ....... : 0xff
$exit
After these settings have been saved to flash memory, the modem configuration ins complete.
A.2.3 Zoom X5 ADSL Modem Model 5654 Setup—Telnet-Only
Accessible Configuration
To set up the Zoom X5 ADSL Modem Model 5654—telnet-only accessible configuration:
1. Open a Windows Command Shell by choosing Run from the Start menu, entering "cmd" in the
Open text box, and clicking OK.
2. In Windows Command Shell, enter "telnet 192.9.0.22," and then press Enter.
3. If the telnet connection succeeds, the Modem displays a "$" prompt.
4. Login with username = admin and password = zoomadsl.
5. Enter the following sequence of commands, wait for a "Set Done" response between commands.
$modify dsl config defaultsgdmt
$modify dsl config bitswap enable
$commit
$get dsl config
4200 SIDE SCAN SONAR SYSTEM USER HARDWARE MANUAL
Response: none, telnet disconnects
Response: "Set Done"
Response: "Set Done"
Response: "Set Done"
Response: config listing
A-12
0004842_REV_N